You can use these steps to update your DSL modem configuration for Bridge Mode. For specific AT&T modem instructions,Â
learn how to set up home networking and enable bridge mode.
- Turn off your computer and DSL modem, then disconnect the Ethernet cable from your computer.
- Connect an Ethernet cable between the Ethernet port of your DSL modem and the WAN or Internet port on your router.
- Connect another Ethernet cable between one of the Ethernet ports on your router to an Ethernet port on your computer. Final setup should look something like this:
![Lynsys router showing (left to right) 1 port for ethernet (WAN - Internet) and 4 ports for computer](http://www.att.com/support_media/images/11/IVR001-Linksys-NetworkDiagram.jpg)
- Turn your DSL modem and router on.
- Turn your computer on.
These steps vary by router manufacturer: - Open a web browser and access the router's user interface, according to the manufacturer's instructions. This is typically done by entering the router's IP address, like 192.168.1.254, into your browser's address bar.
- For router's User Interface, select Internet Connection, enter PPPoE, your DSL network username, and password.
- Save your settings.
You should now be connected to the Internet.
Important: AT&T Tech Support only supports routers from AT&T. For more help, contact your router’s manufacturer.