Connect your U-verse receiver to your HDTV with HDMI cable
Follow the steps to connect your U-verse receiver to your HDTV with an HDMI cable
Set up your HDTV (PDF, 741.50 KB)
Use our PDF guide to set up your HDTV with HDMI and component connectors. View PDF
Get connected
Let’s get started
On the back of the AT&T U-verse receiver, look for the connection HDMI. Connect the HDMI (shown above) to your television. Do not disconnect any Network or TO WALL cables.
Plug your AT&T U-verse receiver into the wall to give it power.
Turn on your TV.
Using your TV's remote control (not your AT&T U-verse TV remote control), select INPUT, TV/Video, or SOURCE to change your TV to the corresponding input. If necessary, refer to your TV's manual to change the input.
Your TV should display the AT&T U-verse screen, Press OK to Watch TV.
Use the AT&T U-verse remote control to press AT&T followed by OK.
Configure your AT&T U-verse receiver for High-Definition (if necessary). Refer to our Quick Fix Guide (PDF)Â for more information.