Connect to AT&T Microcell
Which device do you want help with?

Connect to AT&T Microcell

Connect your device to the AT&T MicroCell.

INSTRUCTIONS & INFO
  1. To use your new AT&T 4G device with an AT&T MicroCell, it must be within signal range and added to the approved user list.
    Note: 2G and non-AT&T devices are not compatible with AT&T MicroCell.
    device 5104/9007004_01.jpg
  2. To add a device to your approved user list, from the home screen of the device you set up as the AT&T MicroCell's primary number, tap the Messaging icon.
    Note: You can also add an approved user by logging in at www.att.com/microcell using your myAT&T account information.
    device 5104/9007004_02.jpg
  3. Tap the Compose icon to send a message to a new recipient.
    device 5104/9007004_03.jpg
  4. Enter the short code 6235 (MCEL) as the recipient of the text message.
    device 5104/9007004_04.jpg
  5. Enter ADD 5555555555 (your device phone number) in the message field, then tap the Send icon.
    device 5104/9007004_05.jpg
  6. When successfully connected to the device, it will show “AT&T MicroCell” or “AT&T M-Cell”.
    device 5104/9007004_06.jpg
  7. If you do not see “AT&T MicroCell” or “AT&T M-Cell”, turn your mobile device (not MicroCell) off, wait 10 seconds and then turn it back on.
    Note: Depending on the signal strength of the AT&T cell tower, the time for your mobile device to switch to the MicroCell can vary. It may take seconds or up to five minutes.
    device 5104/9007004_07.jpg
  8. To manually scan for the AT&T MicroCell, swipe down from the notification bar, and then tap the Settings icon.
    device 5104/9007004_08.jpg
  9. Tap the CONNECTIONS tab then tap More networks.
    device 5104/9007004_09.jpg
  10. Tap Mobile networks.
    device 5104/9007004_10.jpg
  11. Tap Network operators.
    device 5104/9007004_11.jpg
  12. Tap Search for AT&T MicroCell.
    Note: Visit the Troubleshoot & Resolve tool to help resolve device and service issues. To learn more about the AT&T Microcell go to www.att.com/devicehowto and select “MicroCell”.
    device 5104/9007004_12.jpg

Did you get the help you needed?